Please note that VisualCron support is not actively monitoring this community forum. Please use our contact page for contacting the VisualCron support directly.


Support
2010-10-26T22:26:41Z
Defaults should apply. However, we need to remove some debug output. Be sure to delete logs from time to time as these logs might get bigger in this version.

Thank you for your testing and patience.

I assume that the KeepAlive is the one that fixed everything which were previously set to false which could cause the Close-Connection (probably)
Henrik
Support
http://www.visualcron.com 
Please like  VisualCron on facebook!
rprastein
2010-10-26T22:27:48Z
Tweaking the settings, the keep-alive seems to be the key one. I can set http 1.0 and disable autoredirect, but only get a failure when I disable keepalive (I didn't check to see what my output was with autoredirect disabled, I'll check that in a minute).

Rebeccah
rprastein
2010-10-26T22:31:23Z
Disabling autoredirect doesn't seem to have any effect in my situation.

Thanks again.
Scroll to Top