Get output from a bat file in standard output - VisualCron

Please note that VisualCron support is not actively monitoring this community forum. Please use our contact page for contacting the VisualCron support directly.

Welcome Guest! To enable all features please Login or Register.

uffe_krifa
No customer Topic Starter

2012-05-21T10:31:04Z

Hi

When i run a remote execute task that calls a bat file, the result in standard output is
"Process with Id: xxxx was completed successfully", not the output that the bat file is generated, can you configure VisualCron so it shows the bat file output ?

//Uffe Thomassen

Sponsor

Forum information

Wanna join the discussion?! Login to your Forum forum account or Register a new forum account

ErikC
Paid support

2012-05-21T12:11:56Z

I'm not sure a 'remote' execute can do this.

You can make your batch file write everthing to a log file and read this logfile wit a file read task instead.

Regards
Erik

Uses Visualcron since 2006.

uffe_krifa
No customer Topic Starter

2012-05-21T12:36:02Z

Hi

What is the purpose with the standard output option under task-main settings then ?

Regards
Uffe

ErikC
Paid support

2012-05-21T13:16:05Z

Hi Uffe,

This checkbox is for showing you the process id, but that's what you allready know 😊. This task doesn't give you the batchfile's output.

Regards,
Erik

Uses Visualcron since 2006.

Support
Official support

2012-05-21T15:09:27Z

True, remote execute does not support execution output. This is by Windows design. The checkboxes are generic but in this case output is also the output you see "Process with id x was started".

Henrik
Support
http://www.visualcron.com
Please like VisualCron on facebook!

ABOUT VISUALCRON

Community forum

Please note that VisualCron support is not actively monitoring this community forum. Please use our contact page for contacting the VisualCron support directly.

Login