Please note that VisualCron support is not actively monitoring this community forum. Please use our contact page for contacting the VisualCron support directly.


hepworthd
2012-08-23T15:14:21Z
I am attempting to create a Performance Trigger based on drive space less than 500 megs, what I am finding is when the drive is less then 500 megs in size, the trigger just keeps on going. Is there a way to trigger the initial without disabling the trigger? Or a way to delay the next trigger from kicking off?

thanks
Sponsor
Forum information
ErikC
2012-08-24T06:34:28Z
hi hepworthd,

I have a simular situation over here. I check several disks in %Free space.
I have two tasks in these jobs, 1st is the email task to inform me, the next task is a wait task of 15 minutes.

You can setup a wait task yourself and determine which time delay you need for the next trigger.

Regards,
Erik
Uses Visualcron since 2006.
hepworthd
2012-08-24T11:42:58Z
Ahh, that should work, thanks. I was attempting to see if there was an option to disable the trigger after first notification, then see if there was a way to enable the trigger again after the drive space was cleaned up, but no luck.

thanks
Scroll to Top